<em id="00x3j"><acronym id="00x3j"><input id="00x3j"></input></acronym></em>
    1. <dd id="00x3j"><noscript id="00x3j"></noscript></dd>
    2. <rp id="00x3j"></rp>
    3. <span id="00x3j"><pre id="00x3j"><sup id="00x3j"></sup></pre></span>

      <dd id="00x3j"><pre id="00x3j"></pre></dd>

      Guided Ejection System - Mould & Die Solutions

      Search
      Go to content

      Main menu:

      Guided Ejection System

      Products > MOULD COMPONENTS > Alignment
       


      A Guided Ejection System is a three-part configuration consisting of a straight Guide Pin, a Roller Ball Cage, and a Steel Bush. When properly installed, it holds the ejector assembly in alignment and supports the weight of the ejector assembly throughout the entire machine cycle. This greatly reduces wear on ejection components and prevents possible cocking of the ejector plates. It is recommended that a minimum of four Guided Ejection Guide Pins and Bushings be installed.

       
       
       
       
      Back to content | Back to main menu 斗牛游戏大厅